Dishwasher

[messymessy]

Is it worth separating a dishwasher into pieces or should I just sell the whole thing as shred?

Any guesses what I might get for a dismantled dishwaher?

[beauanderos]

Is it worth separating a dishwasher into pieces or should I just sell the whole thing as shred?

Any guesses what I might get for a dismantled dishwaher?

Twenty years to Life... unless it was justifiable homicide.

[AdamsSamoa]

not much there... I scraped one a while back and took a sledge hammer to knock off the motor in the bottom... did not break it apart... sold it as "electric motor".

[AdamsSamoa]

Oh, and there was an Al plate in there that came loose after I knocked the electric motor off.

[messymessy]

Is it worth separating a dishwasher into pieces or should I just sell the whole thing as shred?

Any guesses what I might get for a dismantled dishwaher?

Twenty years to Life... unless it was justifiable homicide.

Too funny. Thanks.

[messymessy]

not much there... I scraped one a while back and took a sledge hammer to knock off the motor in the bottom... did not break it apart... sold it as "electric motor".

Sounds easy enough. Thanks.

[Dr. Cadmium]

Don't forget the wires and any brass fittings. Yards near me will buy them as light iron or shred, regardless of what components are attached.

A lot of modern appliance motors have aluminum windings, and are worth less per pound. $0.11/lb vs. $0.17/lb near me.

[cwgii]

si took one apart this week. casing is clean sheet, frame came apart easy too. wire harness, and motor. took me a half hour. worth maybe 4.00