Discussions about scrap yards, scrap yard prices, melting, refining, and obtaining metals from scrap or unconventional sources.
by flyingboujanero » Tue Apr 17, 2012 12:17 pm
Hey guys- my first post on realcent- i've been a member here for a little bit (came over from BullionStackers).
I recently bought my parents house and have moved in and have been updating the electrical. I've switched out most outlets and receptacles but have been holding on to them.
Question: I know there is copper in the outlets and receptacles. Is there any place that takes them for scrap? Are they worth keeping?
Thanks for any and all input.
-
flyingboujanero
-
- Posts: 25
- Joined: Mon Oct 31, 2011 12:30 am
by hobo finds » Tue Apr 17, 2012 6:26 pm
There is a fair amount of brass in them some prople just smash them and take the brass. Any steel, ins wire or copper just put in the correct bucket untill you go to your yard! And welcome
-
hobo finds
- Too Busy Posting to Hoard Anything Else
-
- Posts: 5956
- Joined: Mon Dec 29, 2008 3:00 pm
- Location: Tucson
by messymessy » Tue Apr 17, 2012 6:59 pm
I've taken them apart and separated the steel, brass and plastic. Seems like a big waste of time for the small amount of metal gained. I've never found anyplace that will buy them whole, although I suppose you could mix them in with shred.
-
messymessy
- Penny Hoarding Member
-
- Posts: 757
- Joined: Wed Apr 07, 2010 3:00 pm
by Dr. Cadmium » Tue Apr 17, 2012 8:35 pm
Reusing electrical outlets isn't the best idea. As they age they become less reliable. It's nice to have a couple of units around for projects if needed, but new ones are cheap enough.
As mentioned above, as scrap they can go as light iron/shred at many yards.
-
Dr. Cadmium
- Penny Hoarding Member
-
- Posts: 899
- Joined: Mon Aug 02, 2010 3:00 pm
- Location: USA
by flyingboujanero » Thu Apr 19, 2012 2:07 pm
Thanks guys for your input.
Dr Cadmium- I wasn't planning on keeping them to use- for sure. Some in the house were going bad and instead of piecemealing it, I decided to switch them all out, due to concerns on the reliability of old outlets.
-
flyingboujanero
-
- Posts: 25
- Joined: Mon Oct 31, 2011 12:30 am
Return to Scrap Metal Salvage
Who is online
Users browsing this forum: No registered users and 7 guests